Installing jaw covers on the BitMoore 925 series vise:

1. Loosen the screws holding one jaw plate of the vise.
2. Lift up on the jaw plate and put a jaw cover in about halfway. Leave one of the screws exposed so that it may be tightened.
   
3. Tighten the exposed screw.
   
4. Slide the jaw cover over so that the other jaw plate screw is exposed.
   
5. Tighten the screw and then slide the jaw cover over to cover the jaw plate.
6. Repeat the above process for the other jaw.
   

Special thanks to Greg English for providing the pictures.